Plastic Couplers

Snap On External

Part #	Duct	Duct Type	Duct OD	Request Quote
TC1.660	1 1/4"	Smooth	1.660	Yes

No Box Quantity!

Its unique toggle design allows for the fastest installation possible. No wrenches, no presses, no problems! These molded couplers can be used for above ground, buried, permanent and temporary applications. They are molded from UV protected glass reinforced nylon, making them impervious to corrosion..

More Info Large Picture

Two Piece External

Part #	Duct	Duct Type	Duct OD	Request Quote
PE1.050-2	3/4"	Smooth	1.050	Yes
PE1.315-2	1"	Smooth	1.315	Yes
PE1.590-2	1 1/4"	Smooth	1.590	Yes
PE1.660-2	1 1/4"	Smooth	1.660	Yes
PE1.900-2	1 1/2"	Smooth	1.900	Yes
PE2.375-2	2"	Smooth	2.375	Yes

No Box Quantity!

This series of reusable air-tight molded couplings was introduced specifically to replace expensive two piece removable metal couplings. The couplings are injection molded of a UV protected glass fiver reinforced nylon, and underground applications with today's blown fiber technology. The couplings are reusable, removable, lightweight, seal completely to 200 lbs. psi.. The coupling body, rubber gasket and stainless steel fasteners are essentially impervious to corrosion. No special tools are required to install the couplings except a battery powered or hand held nut driver.

More Info Large Picture

Plastic Internal

Part #	Duct	Duct Type	Duct OD	Request Quote
PI1.00	1"	Corrugated	1"	Yes
PI1.25	1 1/4"	Corrugated	1 1/4"	Yes

No Box Quantity!

This is the design that has become the industry standard for tapered internal couplings for corrugated innerduct. The tapered body of the coupling expands the duct wall sufficiently to maintain the full inside diameter of the conduit.

More Info Large Picture

Plastic External 2 Piece Sleeved

Part #	Duct	Duct Type	Duct OD	Request Quote
PEC1.350-2	1"	Corrugated	1"	Yes
PEC1.575-2	1 1/4"	Corrugated	1 1/4"	Yes

No Box Quantity!

This innovative series of threadless couplings for corrugated innerduct was designed to be a lower cost alternative to metal couplers and can be used in the same type of applications. Installation time is greatly reduced over any type of thread-on couplings. The installation consists simply of sliding an outer sleeve over the internal component which has ribs which match the corrugation pattern of the innerduct.

More Info Large Picture

Plastic Barbed

Part #	Duct	Duct Type	Duct OD	Request Quote
PB1.900	1 1/2"	Smooth	1 1/2"	Yes
PB2.375	2"	Smooth	2"	Yes

No Box Quantity!

Cabletec's plastic barbed ring coupler series incorporates the same superior design as our aluminum barbed compression couplings, with the additional benefit of a substantial savings over metal.

More Info Large Picture

Plastic Threaded for SIDR Duct

Part #	Color	Duct Type	Duct OD	Request Quote
SIDR9T	Black	Smooth	SIDR 9T	Yes
SIDR11T	Orange	Smooth	SIDR 11T	Yes

No Box Quantity!

Cabletec's new line of plastic couplers to fit SIDR 9 & 11.5 True duct are an excellent alternative to metal couplers.

More Info Large Picture